Heater placement questions
Heater placement questions
I just got a new heater for my 20 gallon tank, but I'm not sure where to put it. Does it matter if it's near the filter or not? Also, should it be horizontal or vertical? I don't wanna mess up the flow or anything.
Re: Heater placement questions
Placement can affect heat distribution. Ideally, position it near the filter outflow to help circulate warm water evenly. Horizontal or vertical doesn't matter as much as ensuring it's fully submerged and not touching the substrate. What kind of heater did you get?
Re: Heater placement questions
I've always put mine near the filter, kinda diagonal so it's not straight up or down. Works fine, but I've heard some folks say horizontal is better for larger tanks. Not sure if that's true though.
-
brookstream - Posts: 4
- Joined: Thu Oct 24, 2024 9:36 pm
Re: Heater placement questions
Yep, near the filter is a solid choice. Just make sure it's not too close to any plants or decor that could block the heat. What's your tank temp right now?
Re: Heater placement questions
Heater placement is key, especially in smaller tanks. If it's too close to the substrate, it can overheat the bottom layer. I'd go vertical near the filter outflow, but avoid direct contact with the glass. What brand heater are you using?
Re: Heater placement questions
I've had mine horizontal for years with no issues. Just keep it away from the substrate and any decor. Also, make sure it's not near the thermometer, or you'll get false readings.
Re: Heater placement questions
Horizontal placement near the filter works best for me. It's out of the way and distributes heat evenly. Just avoid putting it near any air stones, as the bubbles can mess with the thermostat.
Re: Heater placement questions
Thanks for the advice, everyone. I'll try placing it near the filter outflow and see how it goes. It's an Aqueon Pro heater, by the way.
-
brookstream - Posts: 4
- Joined: Thu Oct 24, 2024 9:36 pm
Re: Heater placement questions
Yeah, Aqueon's a solid brand. Let us know how it works out. If the temp's all over the place, you might need to adjust the placement a bit.